|
Have to hold the motor
|
You have to hold up the motor to remove the two big bolts for the til/trim unit.
|
|
|
To of the bolts are missing and 1 is actually broken
|
Notice the 5 bolts?
|
|
Trim cylinder
|
Needed repair.
|
|
|
Notice the line on the trin cylinder? It should be straight with the base. As the bolts are missing its a wonder it worked at all.
|
The trim cylinder is not straight
|
|
These were the olny bolts left
|
1 of these is broken be remanded in the hole. 1 is actaully bent the other is Ok but was very loose. The spec call for 95 inch pounds to all 5 bolts.
|
|
The tilt cylinder should have has the 2 O rings replaced. I could not find or buy a spanner wrench that fit. I needed the smaller pined adjustabe type and got the bigger 1. If the tilt goes out I will fix it then. Same with the pump and motor.
|
Tilt Cylinder
|
|
Trim removed
|
I got fed up with the tim failing and takeing the tilt away also. I was informed to plug the trim hole in the pump and just use the tilt. So far works fine.
|
|
|
(Insert New Description)
|
My old prop and new
|
|
old prop blade
|
(Insert New Description)
|
|
|
(Insert New Description)
|
New prop blade
|
|
(Insert New Caption)
|
(Insert New Description)
|
|
|
(Insert New Description)
|
(Insert New Caption)
|
|
(Insert New Caption)
|
(Insert New Description)
|
|
