|
|
 |
|
| home |
| |
shopping |
| |
contact |
| |
projects |
| |
Warning: Undefined array key "session_logged_in" in /home2/sap/public_html/header.php on line 612
login | | | join |
|
|
|
|
Snowblower Repairs
|
 |
|
|
|
|
|
|
|
|
|
|
|
How do you get a bearing separator in THERE?
|
|
I borrowed a friends hydraulic press and I THOUGHT I would just put the entire 2 augers and center gear box in the press and press the shaft out of the augers, one side at a time. I was working on a split table for the press so I could work around the gear box to get the 1st auger off, when if finally dawned on me that this is a rather TIGHT fit.
As it turns out I could not, even without the press, get a bearing separator between the gear box and the end of the center pipe of the auger. It simply would not fit in there.. There is NO room. And, you can not get the gear box apart or off until you get at-least ONE of the augers off.
So how in the world do you get this off? Pressing it won't work.. SO I guess you have to PULL on it?
|
|
|
|
|
|
|
|
|
All projects on Shareaproject.com are user-submitted and should be used for reference information only. The projects are not intended to be complete "How-To" articles. Use the information contained in these projects at your own risk. Projects are not checked for completion, accuracy, or safety and therefore cannot be guaranteed in any way.
Outdoor Blog
|
