|
|
 |
|
| home |
| |
shopping |
| |
contact |
| |
projects |
| |
Warning: Undefined array key "session_logged_in" in /home2/sap/public_html/header.php on line 612
login | | | join |
|
|
|
|
Johnson 90 hp Repower
|
 |
|
|
|
|
|
|
|
|
|
|
|
Assembled Junction Box
|
|
|
Two stainless steel 5/16 x 2" carraige bolts are used for the studs. The sides of the heads are ground flat so they will not spin in the epoxy. About 3/8" is cut off the end so the bolts fit inside the box, then 4 ounces of epoxy is poured in. Note that the epoxy got so hot that it expanded a bit around the parimiter. But the bolts are held in tight. A couple of nuts, washers and wing nuts complete the hardware. Cut a 3/4" wide slot in the bottom to feed the 4 AWG cables through. And labeled the posts Positive and Netagive to prevent accidental crossing of cables.
|
|
|
|
|
|
|
|
|
All projects on Shareaproject.com are user-submitted and should be used for reference information only. The projects are not intended to be complete "How-To" articles. Use the information contained in these projects at your own risk. Projects are not checked for completion, accuracy, or safety and therefore cannot be guaranteed in any way.
Outdoor Blog
|
