|
|
 |
|
| home |
| |
shopping |
| |
contact |
| |
projects |
| |
Warning: Undefined array key "session_logged_in" in /home2/sap/public_html/header.php on line 612
login | | | join |
|
|
|
|
Engine tear down, reassembly and tuning
|
 |
|
|
|
|
|
|
|
|
|
|
|
Clean the block
|
|
After you're done deglazing, you must remove every trace of grit from the hone. This means careful scrubbing with dish detergent and hot water. I use a stiff bristled tooth brush. Clean and clean again.
Immediately after cleaning, wipe the cylinder walls with a TC-W3 outboard oil soaked rag. If you do not, they will start rusting in no time.
For some reason this picture didn't come out very well. The crosshatch is in fact a lot nicer than it appears.
|
|
|
|
|
|
|
|
|
All projects on Shareaproject.com are user-submitted and should be used for reference information only. The projects are not intended to be complete "How-To" articles. Use the information contained in these projects at your own risk. Projects are not checked for completion, accuracy, or safety and therefore cannot be guaranteed in any way.
Outdoor Blog
|
