|
|
 |
|
| home |
| |
shopping |
| |
contact |
| |
projects |
| |
Warning: Undefined array key "session_logged_in" in /home2/sap/public_html/header.php on line 612
login | | | join |
|
|
|
|
14 Ft 'Ski-Boy' Restore - Tiny-Tannic
|
 |
|
|
|
|
|
|
|
|
|
|
|
How to keep panels straight
|
|
Because our plywood was bowed, we needed to hold it flat while the lamination was setting up. We attached two straight 2 x 4's to the first layer with finish nails, just like we did to keep the floor flat. Now that the resin is setup we can pry these off and again the nail heads pulled through the plywood, so no steel is left to worry about.
Also, since our stainless steel screws are 1 5/8 inch long and 2 pieces of "3/4" (actually 23/32 inch thick) plywood is only 1 1/2 inches we have the points of screws sticking through. Five minutes with the grinder and we had those all cleaned up.
|
|
|
|
|
|
|
|
|
All projects on Shareaproject.com are user-submitted and should be used for reference information only. The projects are not intended to be complete "How-To" articles. Use the information contained in these projects at your own risk. Projects are not checked for completion, accuracy, or safety and therefore cannot be guaranteed in any way.
Outdoor Blog
|
