|
|
 |
|
| home |
| |
shopping |
| |
contact |
| |
projects |
| |
Warning: Undefined array key "session_logged_in" in /home2/sap/public_html/header.php on line 612
login | | | join |
|
|
|
|
14 Ft 'Ski-Boy' Restore - Tiny-Tannic
|
 |
|
|
|
|
|
|
|
|
|
|
|
Cutting foam to fit
|
|
The center channel is almost exactly 2 inches deep so installing the foam there was VERY easy. We did cut several grooves in the bottom side of this for water to pass to the bilge.
The side area are a little more fun. Because the hull curves up on either side, we had to measure for each piece and cut then to smaller and smaller thicknesses.
We tried to stand the foam on edge and draw a line where to cut it, but we wound up measuring and cutting the pieces on the bandsaw. Man does that bandsaw make nice work on this foam.. IT cuts a VERY narrow kerf and leaves a nice clean edge.
|
|
|
|
|
|
|
|
|
All projects on Shareaproject.com are user-submitted and should be used for reference information only. The projects are not intended to be complete "How-To" articles. Use the information contained in these projects at your own risk. Projects are not checked for completion, accuracy, or safety and therefore cannot be guaranteed in any way.
Outdoor Blog
|
