|
|
 |
|
| home |
| |
shopping |
| |
contact |
| |
projects |
| |
Warning: Undefined array key "session_logged_in" in /home2/sap/public_html/header.php on line 612
login | | | join |
|
|
|
|
14 Ft 'Ski-Boy' Restore - Tiny-Tannic
|
 |
|
|
|
|
|
|
|
|
|
|
|
Starting to make a pattern for the floor.
|
|
March 11, 2006
After a number of measurements we figured out that we could use 1 4 ft by 8 ft sheet of 1/2 inch A/C exterior plywood to replace almost the entire boat floor. The sheet will end 16 inches from the transom. That leaves a nice piece to install with the transom replacement.
Also at the Very rear of the floor the width is 50 inches so we will have to add a narrow strip to the one side.
To make the pattern, we cleaned everything up. We placed the old front floor section back in place and stapled card board to it as an extension. To hold the cardboard at the right height and give us a good working and writing surface we laid a scrap piece of 1/2 inch ply across the rear stringers.
|
|
|
|
|
|
|
|
|
All projects on Shareaproject.com are user-submitted and should be used for reference information only. The projects are not intended to be complete "How-To" articles. Use the information contained in these projects at your own risk. Projects are not checked for completion, accuracy, or safety and therefore cannot be guaranteed in any way.
Outdoor Blog
|
